top of page

 

Product Details

 

  • JACK UP-ANTIVIBRATION MOUNT FOR CONCRETE FLOATING FLOORS#

  • SUITABLE FOR RAISED CONCRETE FLOATING FLOORS.

  • REGULATION OF HEIGHT. AVOID REMAINING PLYWOOD FORMS.

  • MONITORING AND EASY REPLACEMENT OF SPRING.

  • COMBINATION OF SPRING AND RUBBER, FOR BETTER ACOUSTICAL RESULTS.

  • CREATES AN AIR-GAP, BENEFICIAL FOR THE SOUND INSULATION AND THE VIBRATION CONTROL..

Vibro JS

(*1Kp=1Kg) 

                                                                  

Different dimensions and load capacities on request.

 

Selection Table

 

 

Installation

 

  1. Place a polyethylene sheeting under and all around surface of the concrete floating floor.

  2. Isolate the floating floor from building structure, with a suitable antivibration board, between the floating floor and the wall (e.g. Vibro-strip).

  3. Place the housing of Vibro-JS and its cover plate.

  4. Place reinforcing of the slab and pour the concrete. (Calculations of the concrete’s quality, adequate reinforcement and other requirements must be done from a Civil Engineer).

  5. Place the internal antivibration system of Vibro-JS.

  6. Screw progressively and uniformly the nut of the elevation mechanism, in order to load the springs and raise – regulate the concrete slab at the appropriate height.

  7. Place cover plate.

bottom of page